Anthem's pinnacle of amplification, the Statement M1 Monoblock Power Amplifier!

The highest sound quality at all volume levels, flat frequency response into any load, and stable into the most difficult loads. The Statement M1 is a state-of-the-art monaural amplifier delivering 1,000 watts into 8 ohms and 2,000 watts into 4 ohms or less with THD remaining under 0.1% from 20 Hz to 20 kHz.

More than just a slim, technologically advanced monaural design, the M1 demonstrates that Class D can be STUNNING, it simply hasn't been implemented well in the past, mainly because it required such a heavy commitment to R&D. Anthem have the in-house resources to create such a groundbreaking product and one listen will reveal the truly extraordinary nature of this amplifier.

SPECIFICATIONS

Power Output continuous, 20 Hz to 20 kHz, <0.1% THD+N

• 8 Ω 1000 W
• 4 Ω 2000 W
• 3 Ω 2400 W
• 2 Ω >2000 W depending on line voltage regulation

With 120V AC supply the amplifier’s maximum output into impedances 4 Ω and lower, as well as its maximum duration, vary depending on line voltage regulation.

Frequency Response 20 Hz to 20 kHz

Open circuit +/- 0.1 dB

• 8 Ω +/- 0.1 dB
• 4 Ω +/- 0.1 dB
• 2 Ω +/- 0.2 dB

THD+N at 1 kHz, 8 Ω

• 1 W 0.01 %
• 10 W 0.01 %
• 100 W <0.03 %
• 1000 W <0.06 %

S/N Ratio: ref. 1000 W, IEC-A 113 dB
Voltage Gain: 29 dB
Input Sensitivity: 100 mV for 1 W output, 3.2 V for 1000 W output (8 Ω)
Input Impedance: 10 kΩ (RCA), 20 kΩ (XLR)
Damping Factor: 800 to 1400 depending on frequency
XLR Configuration: Pin 1 Ground, Pin 2 Positive, Pin 3 Negative

POWER REQUIREMENTS

Consumption in a typical music/cinema installation

• standby mode, 120V mains <1 W
• standby mode, 240V mains <2 W
• operate mode, idle 33 W
• typical operation 300 W

Where mains voltage is 120V, one dedicated 15A circuit per amplifier is recommended depending on speaker. A 20A circuit is adequate for two amplifiers playing music where speaker impedance is 8 Ω. This product operates from a single phase AC power source that supplies between 108V and 264V at a frequency of 50 or 60 Hz.

DIMENSIONS

Height with feet: 2 1/4 inches (5.7 cm)
Height without feet: 1 rack unit
Width standard handles: 19 1/4 inches (49 cm)
Width rackmount handles: 19 inches (48.3 cm)
Depth: 18 3/4 inches (47.6 cm)
Weight: (unpacked) 20 lb (9 kg)